Use a positive value for cut and a negative value for fill. The model assumes constant width and a linear grade difference between the ends.
Measurement and material estimate
- In-place cut
- 4.087 yd³
- Loose excavated volume
- 4.087 yd³
- Compacted fill
- 1.471 yd³
- Loose material for fill
- 1.471 yd³
Trips are estimated from the entered volume. Use factors for the actual material. Cut and fill are calculated separately without assuming reuse.
Report a problem
How it works
Enter the horizontal length and constant width.
Use positive values for cut and negative values for fill.
Enter material factors and optionally a usable truck volume.
Frequently asked questions
How does the calculator separate cut and fill?
Grade difference changes linearly between endpoints. When the signs differ, the model splits the section where the difference reaches zero and calculates the volumes separately.
Which volume is used for truck trips?
Trips use the loose volume and the entered capacity. Check the vehicle's weight capacity for the actual material as well.